/ Installation Tips for 3 Gang Wall Plates

Installation Tips for 3 Gang Wall Plates

Here are some installation tips for 3 gang wall plates:

1. Choose the right location: Before installing the 3 gang wall plate, choose a location that is easily accessible and provides enough space for the cable slack. Make sure the location is also free from any potential hazards or obstructions.

2. Gather the necessary tools: You will need a hammer, cable slack, cable snips, and a screwdriver to install the 3 gang wall plate. Make sure you have all the necessary tools before starting the installation process.

3. Cut the cable slack: Use cable snips to cut the cable slack to the desired length. Make sure to leave enough slack to allow for future adjustments.

4. Strip the cable: Use cable snips to strip off about 1/2 inch of the outer jacket of the cable. Be careful not to damage the inner wires during this process.

5. Connect the wires: Connect the wires from the cable to the corresponding ports on the 3 gang wall plate. Make sure to follow the proper wiring configuration for your electrical system.

6. Secure the wall plate: Use a screwdriver to secure the 3 gang wall plate to the wall. Make sure it is firmly attached and cannot be easily removed.

7. Test the connection: Once the 3 gang wall plate is installed, test the connection by plugging in your devices and checking for proper functionality.

By following these simple installation tips, you can ensure that your 3 gang wall plate is installed correctly and provides reliable electrical power for your devices.

Request A Quote​

Can’t find the specific information you’re looking for? Have a question ? Contact Us